Altronix AL600ULACM 8AC outlet(s) Grey power extension

AL600ULACM converts 115VAC 60Hz inputs into eight (8) independently controlled 12VDC and/or 24VDC outputs with a max continuous supply voltage of 6 amps.

Convert power outputs into dry form "C" contacts.

Open collector sinks or normally open (NO) dry trigger inputs are available from Access Control Systems, Card Readers, Keypads, Push Buttons, and PIR sensors.

Altronix ACM AL600ULACM unit can power access control hardware devices such as magnetic door holders, electric strikes, and mag locks.

Both Fail-Safe and Fail-Secure outputs are supported.

In Altronix AL600ULACM, power can come from either a single power source (factory installed) that will supply power for both the operating board and the locking devices or two (2) totally independent sources, one (1) for board operation, one (1) for locking/accessory power.

This interface allows Emergency Egress, Alarm Monitoring, or other auxiliary devices to be triggered.

All eight (8) outputs can be individually selected for fire alarm disconnection.

Power Supply/Charger:

• 12VDC or 24VDC selectable output;
• 6 amp of continuous supply current;
• 115VAC 60Hz, 1.9 amp input;
• Filtered and electronically regulated outputs;
• Short circuit and thermal overload protection;
• Maximum charge current .7 amp;
• Zero voltage drop upon transfer to battery backup;
• AC input and DC output LED indicators;
• AC fail supervision (form "C" contact rated @ 1 amp 28VDC);
• Low battery and battery presence supervision (form "C" contact rated @ 1 amp 28VDC);

Access Power Controller:

• Eight (8) Access Control System outputs;
• Eight (8) fuse protected Fail-Safe and/or Fail-Secure 12VDC or 24VDC power outputs;
• Eight (8) fuse protected 12VDC or 24VDC auxiliary power outputs (unswitched);
• Red LEDs indicate outputs are triggered (relays energized);
• Eight (8) Access Control System trigger inputs;
• Eight (8) normally open (NO) inputs;
• Eight (8) open collector inputs;
• Any combination of the above;

Fire Alarm Disconnect:

• Fire Alarm Disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs;
• Normally open (NO) or normally closed (NC) dry contact input;
• Polarity reversal input FACP signaling circuit;
• Fire Alarm trigger LED indicates that the Fire Alarm Disconnect has been activated;
• Fire Alarm output relay for triggering auxiliary reporting devices (form "C" contact rated @ 1 amp 28VDC);